Daily Archives: January 3, 2014

Fuel tank replacement

The fuel tank cannot be emptied by sucking the gasoline through the filler pipe. as the ball check valve located therein prevents the insertion of the tube. … read on

Checking and adjusting the ignition advance angle
In the engine 1,3 alignment marks consist of a notch on the crankshaft pulley and an indicator on the pump housing … read on

TRANSISTOR IGNITION (ENGINE 1,3)

Electronic engine ignition system 1.3 It is equipped with a contactless ignition distributor with a magnetoinductive sensor and an electronic module.

In the engine compartment … read on

Checking the elements of the ignition system

The ignition coil

The efficiency of the ignition coil can be checked as follows.

■ Remove the end of the lead wire from the ignition coil from the distributor cap.

■ Remove the manifold cap.

■ … read on

Checking and adjusting the ignition advance angle

The operation of checking the ignition advance angle should be preceded by the control of the contact shorting angle. This angle should be 47 …53° and is measured with the engine running … read on

The replacement of the circuit breaker contacts and the adjustment of the spacing between them is carried out as follows.

■ Remove the cover above the ignition distributor.

■ Remove the manifold cap, by releasing the springs or unscrewing the screws.

■ Remove … read on

CLASSIC IGNITION (ENGINE 1,2)

Engine 1,2 is equipped with a conventional ignition system, which consists of an ignition coil, the ignition distributor, high voltage cable and spark plugs.

Checking and replacing the manifold … read on